Last updated on:
NAYIF-1 STATUS
Last data sequence number: , Frametype: , Created:
STATE
| ASIB | EPS |
| PA | RF |
| ANTS BUS A | ANTS BUS B |
| iMTQ | |
|
| |
| Hardware ABF | Software ABF |
| VHF A | VHF B |
| UHF A | UHF B |
| Command counter | |
| Last command | |
| command success | |
POWER STATUS
| Panel voltage 1 | | mV | Panel Current 1 | | mA |
| Panel voltage 2 | | mV | Panel Current 2 | | mA |
| Panel voltage 3 | | mV | Panel Current 3 | | mA |
| Total Photo Current | | mA | Total System Current | | mA |
| Battery Voltage | | mV | MPPT mode | | |
| Reboot count | | | Reset Cause | | |
| Bus Voltage 3V3 | | mV | Bus Voltage 5V0 | | mV |
| Receiver Current | | mA | RF tx Current 3v3 | | mA |
| RF tx Current 5v | | mA | PA Bus Current | | mA |
| iMTQ current | | mA | iMTQ latch-up count | | |
iMTQ
| iMTQ uptime | | s |
| config set | |
| Mode | | | Error code | | |
TEMPERATURES
| Antenna Temperature A | | °C | Antenna Temperature B | | °C |
| PA FET Temperature | | °C | RF Board Temperature | | °C |
| Boost converter 1 | | °C | Boost converter 2 | | °C |
| Boost converter 3 | | °C | Battery Temperature | | °C |
| iMTQ MCU | | °C |
SUN SENSORS
| sun sensor X+ | | counts | sun sensor X- | | counts |
| sun sensor Y+ | | counts | sun sensor Y- | | counts |
| sun sensor Z+ | | counts | sun sensor Z- | | counts |
RADIO
| Forward Power | | mW | Reflected Power | | mW |
| Doppler voltage | | | |
Please note: The data is continuously being monitored. There is no need to contact us when items indicate red.